Priming The Pumps; Maintenance - TMC REEF EASI-Dose Instructions For Installation And Use Manual

priMing tHE puMps

Once you have set all of your desired settings you will need to prime each pump before
dosing can begin. Priming is the action of making the dosing pump manually take in liquid and
pass it to the end of the tubing so it is ready to dose into your desired location.
1. Press button A (Pump/OK) a number of times to scroll through and select the relevant
pump you need to prime.
2. Press button D (Manual Feed/+) and hold until your chosen dosing liquid exits out of the
hosing into your chosen dosing location e.g. sump.
3. Select the next pump to prime by pressing button A (Pump/OK) and repeat the process
until all pumps are primed as required.
Useful Tip: Using button D (Manual Feed/+) you can also manually dose additives as and
when required.

MaintEnancE

1. Regularly check all connections to make sure they are secure and that the EASI-Dose unit
is functioning correctly.
2. During routine maintenance, the dosing pump heads and the silicone hosing must be
checked for any signs of wear or degradation and must be replaced accordingly. Failure to
do so could result in dosing inaccuracies, operating problems and damage to the dosing
pump. Spares are available from your local stockist. These consumable items are not
covered under the 12 month guarantee (please see back page for details on all available
accessories and spares).
rEplacing tHE dosing puMp HEad
1. To replace the dosing pump head, squeeze the left and right tabs
either side of the head and gently but firmly pull the pump head
forward.
2. To replace, ensure the pump shaft sits centrally in the dosing
pump head and push onto the EASI-Dose unit, ensuring the clips
are aligned left and right. Firmly push the dosing pump head on
until it clicks into place. Check the pump head is operational by
pressing and holding button D (Manual Feed/+) until liquid is
successfully passing through.
9