Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Gates Underwater Products EM50
Summary of Contents for Gates Underwater Products EM50
-
Page 1: Setup, Use, And Care Guide
EM50 External Monitor Setup, Use, and Care Guide... - Page 2 Cautions Page 2 Copyright 2013, Gates Underwater Products, Inc. Last document revision: 7-1-2013 Photos © Gates Underwater Products This manual and current revision is available in 8.5 x 11 size and full color at http://www.gateshousings.com/documentation.html Gates Underwater Products, Inc. 13685 Stowe Drive...
-
Page 3: Table Of Contents
Cautions Page 3 Table of Contents Setup, Use, and Care Guide ..........1 Introducing the EM50 External Monitor ......4 Features ................4 Warranty Disclaimer ............4 Unpacking the EM50 ............5 1: Cautions ................6 2: EM50 Setup ............... 7 ... -
Page 4: Introducing The Em50 External Monitor
Please read through this entire guide to learn about the EM50 so you can get the most out of this imaging tool. In this section, we’ll introduce you to the features of the EM50 so you can get started. -
Page 5: Unpacking The Em50
Page 5 Unpacking the EM50 After you remove the EM50 from its shipping container, carefully inspect it for missing parts or damage that may have occurred during shipment. If you discover any discrepancies, contact Gates or your dealer immediately for assistance. -
Page 6: 1: Cautions
USER RESPONSIBILITY. This Setup, Use and Care guide contains important detailed procedures for setup and use of the EM50. It is the user’s responsibility to read, understand and employ these procedures. Failure to do so can result in poor or non-operation of the EM50 and may void your warranty. -
Page 7: 2: Em50 Setup
(charging). The batteries will take up to 2 hours to fully charge. Open the housing . Position the EM50 with the Battery Cover facing up as shown. Release the four latches and the battery cover will separate. Install and plug in the battery. - Page 8 EM50 Setup Page 8 Battery Cover. Battery. Connect or disconnct the battery to EM50 here. After closing, inspect the seal line around the housing. It should be even with no gaps.
-
Page 9: Monitor Mount / Video Connections
Page 9 Monitor Mount / Video Connections Mount the EM50 monitor . Secure the monitor to the top of the housing shell. An example is shown below. Tighten the thumbscrews to secure. Insert the Monitor Cable into the housing. Refer to the illustration which shows the F55 Housing. - Page 10 EM50 Setup Page 10 Insert the EM50 Monitor Cable into the housing as shown. Tighten the brass collar until snug. Route the Monitor Cable to the rear of the housing as shown. Here it will connect to the camera.
- Page 11 EM50 Setup Page 11 Plug in the HDMI Adapter Cable into the camera. F55 housing shown.
-
Page 12: Em50 Controls
EM50 Setup Page 12 EM50 Controls Controls. See the image below for the functions assigned to each Pushbutton control. Peaking Power Scaling “UP” Menu Navigation MENU “DOWN” Menu Navigation Power Status = Off = On GREEN No Indiction = No Power... -
Page 13: Em50 Operation
When within the menu, press this button to exit. Battery Life. The EM50 will operate up to 6 hours on a fully charged battery. EM50 Travel / Transport Some notes about traveling with the EM50 Disconnect Batteries. -
Page 14: 3: Em50 Maintenance
O-Ring Care and Maintenance Your Gates EM50 External Monitor has 1 serviceable o-ring. It is located on the main housing where the Battery Cover mates. Its color is orange. Servicing the o-rings is easy and covered in the “Housing Care and Maintenance”... -
Page 15: 4: Customer Support
Customer Support Page 15 4: Customer Support Should you have any questions about the EM50 and its operation, please contact Gates at the numbers below. Email: Customer.srvc@GatesHousings.com Web: www.GatesHousings.com Phone: 858.391.0052 Fax: 858.391.0053...