Advertisement
Step 4
Connecting iPod module
a
Cut hole to a standard single-gang wall plate size (75mm H x 45mm W)
b
Pull cable through
c
Connect RJ-45 terminated cable to module (fig5)
d
Screw on to wall
Step 5
A-BUS/
DIRECT
a
Cut hole to speaker cut out dimensions (Forte 6.5" = 206mm dia x 79mm depth)
b
Pull cable through
c
Connect RJ-45 terminated cable to Amplified IR speaker (fig 6)
d
Connect speaker wire between the two to the clip terminals (fig 6)
e
Do not screw into ceiling yet
Step 6
Power up
a
Turn on power supply
b
Turn on iPod and press play
c
Turn volume up on Amplified speakers in each room, confirm music is playing.
Step 7
Final set up
a
Turn volume up to maximum required level then adjust the trimpots on back
of Amplified IR speaker. This sets max volume level (fig8)
b
Screw speakers into ceiling
c
Test iPod control from each room, by pointing remote at Active IR speaker and
change track (iPod control are pre-programmed on source 1)
d
When using single IR speaker select mono on back of speaker (fig 9)
e
For programming keypad with wall cradle, see ABR-43 (fig 7) instructions
For more detailed installation information including expansion, see appropriate Hub Manual
Speakers
FIG 5
FIG 6
FIG 7
FIG 8
FIG 9
Advertisement
