Optiguard STAND Smart S Installation Instructions

Download this manual

WARNING!

After connecting the device to a charger, a periodically blinking yellow diode in the base indicates lack of any programmed remote controls.

The image below shows the components needed to assemble the

whole system.

1) Stand Smart S

2) smartphone

3) USB 5V/2A power supply

4) cleaning tissue with izopropylan

Optiguard sp. z o.o.

ul. Aleksandrowska 6-10, 87-100 Toruń

NIP 956-213-03-91

Phone +48 56 654 71 33

STAND Smart S

INSTALLATION INSTRUCTIONS

SUGGESTED USE



Stand Smart S is the standalone anti-theft protection dedicated to

smartphones and tablets.



UMH3 sensor ensures an aesthetic product presentation at an angle

of 30 degrees.



Small size assured optimum visibility of the product.

Cleaning tissue with izopropylan assures the proper preparation

of the surface under Optiguard stickers.

1 / 5

Page 1 INSTALLATION INSTRUCTIONS STAND Smart S SUGGESTED USE  Stand Smart S is the standalone anti-theft protection dedicated to smartphones and tablets.  UMH3 sensor ensures an aesthetic product presentation at an angle of 30 degrees.  Small size assured optimum visibility of the product.
Page 2: Installation Instructions
STAND Smart S Using the cleaning tissue with izopropylan, we can prepare the surface of the furniture, to which Stand Smart S will be attached. After cleaning the furniture, wait until the cleaning Take off the protective papers from the stickers.
Page 3 INSTALLATION INSTRUCTIONS STAND Smart S Using the cleaning tissue with izopropylan, we can prepare the surface of the furniture, to which the sensor will be attached. After cleaning, wait until the cleaning substance evaporates. Take off the protective paper from the sticker of UMH3 sensor.
Page 4 Plug the end of the cable with the sticker of "ALARM" in USB of the smartphone. Stand Smart S and allows to charge the protected product. Plug the cable from Stand Smart S with USB connector in the Plug USB charger with connected Stand Smart S into a power charger with USB port.
Page 5 INSTALLATION INSTRUCTIONS STAND Smart S Powered Stand Smart S will activate within 3 seconds. Short acoustic signal and periodically blinking red LEDs in the sensor confirm activation of the system. Finished! Optiguard sp. z o.o. ul. Aleksandrowska 6-10, 87-100 Toruń...