Franke ANCONA ANX 110-48 Installation Instructions

FRANKE
ANCONA SINGLE BOWL
UNDERMOUNT SINK - ANX 110-48
FEATURES
Model ANX 110-48
Bowl configuration Single bowl
Stainless steel with cr=36 mm corners,
Bowl(s)
rear waste and overflow
Stainless steel
Finish
Fixing clips
Fixing
Colours N/A
SPECIFICATIONS
Domestic
Recommended use
Stainless steel
Material
Formation Pressed 1 piece
N/A
Tap Holes
510 x 430 mm
Dimensions
480 x 400 x 190 mm/35 L
Bowl Size
Template
Cut Out
600 mm
Cabinet Size
90 mm
Waste Outlet
Hidden overflow, sound deadening pads
Features
Optional accessories: Franke extension drainer,
Accessories
rollamat, drainer basket and strainer bowl
ANX 110-34
Models available
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product
warranty - refer to Warranty Conditions on the last page.
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from
their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs
listed are correct at time of publication however the manufacturer/distributor takes no responsibility for
printing errors.
Tech Page Version 1
510
480
To see the complete FRANKE range go to
www.reece.com.au/bathrooms
page 1 of 3