Hearth & Home IntelliFire Plus RC100 Installation & Operating Instructions

Hearth & Home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modifi cation of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
• Read, understand and follow these instructions for safe
installation and operation.
Introduction
The RC100 wireless wall switch is designed to turn
f i r e - p a r t s . c o m
your gas fi replace on and off. The RC100 wireless wall
switch is only for use with the Hearth & Home Tech-
nologies IntelliFire Plus™ system (IPI).
FCC Requirements
WARNING! Risk of Fire! Changes or modifi cations to
this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful in-
terference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Contact the dealer or an experienced radio TV techni-
cian for help.
IntelliFire Plus™ Wireless Wall Switch
Installation & Operating Instructions
Hearth & Home Technologies • RC100 Wireless Wall Switch • 2166-391 Rev. C • 9/10
RC100
Canadian Equipment Requirements
This digital apparatus does not exceed the (Class A/ Class
B) limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Cana-
dian Department of Communications. Le present appareil
numerique n'emet pas de bruits radioelectriques depas-
sant les limites applicables aux appareils numeriques (de
la class A/de la class B) prescrites dans le Reglement sur
le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
This device complies with RSS-210 of Industry and Science
Canada. Operation is subject to the following two condi-
tions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
Wall Switch Location Requirements (For Ap-
pliances Installed Outside The United States
And Canada)
This wireless wall switch must be installed a minimum of
44 inches (112 cm) above the fl oor. This measurement is
taken from the from the center of the wall switch.
Installation Precautions
This wall switch is tested and safe when installed in ac-
cordance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must
be done by a qualifi ed service technician.
Placement of this wall switch may affect performance. An
assessment of the space should be done prior to installa-
tion for optimum performance.
Determine Location
Determine the location for the wireless wall switch. The
selected location should be in the same space as the gas
fi replace with visual sight of fi replace. The wireless wall
switch must be placed within 30 feet (9.14 m) of the fi re-
place but should not be exposed to extreme heat.
The RC100 is approved for interior installation and should
always be placed under weather resistant cover when used
in exterior applications.
1