Connecting To A Pc - Denso DST-i Series Instruction Manual

1 Before Use

Connecting to a PC

To connect by USB communication
Use the USB cable and the USB spacer to connect this product to a PC .
CAUTION
• Insert the USB spacer securely to the depth of the USB cable connector .
• It is necessary to install the software on a PC before connecting the USB cable to a PC.
1. Connect the PC side connector of the USB cable to the USB port of the PC .
2. Attach the USB spacer to the DST-i side connector of the USB cable .
3. Connect the DST-i side connector (with the USB spacer attached) to this product.
Marking
Connect the PC side connector to USB port.
NOTE
• When connecting both the datalink cable and the USB cable at the same time, attach the USB cable lock to the USB
cable beforehand .
- Refer to "When connecting both the datalink cable and the USB cable at the same time" (page 6).
• The power supply of this product is turned ON by sliding the mode switch to the ON position after connecting to a PC.
• When USB communication with the PC is established, the PC communication (USB) indicator on this product
flashes green.
Place the notch portion on
USB spacer
USB cable
marking side.
- 4 -
T02751E