Pride Mobility GT Owner's Manual page 27

V I I I . C A R E A N D M A I N T E N A N C E
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See
fi gure 16.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse
must exactly match the rating of
the fuse being replaced. Failure to
use properly rated fuses may cause
damage to the electrical system.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly or disassembly of the scooter must
be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert,
resulting in a less secure fi t. Replacement nylon insert lock nuts are available at local hardware stores or through
your authorized dealer.
STORING YOUR SCOOTER
If you plan on not using your scooter for an extended period of time, it is best to:
 Fully charge its batteries prior to storage.
 Disconnect the batteries from the scooter.
 Store your scooter in a warm, dry environment.
 Avoid storing your scooter where it will be exposed to temperature extremes.
 Recommended storage temperature: -40ºF/-40ºC to 149ºF/65ºC.
WARNING! Always protect batteries from freezing temperatures and never charge a frozen
battery. Charging a frozen battery can result in damage to the battery.
Batteries that are regularly and deeply discharged, infrequently charged, stored in extreme temperatures or stored
without a full charge may be permanently damaged, causing unreliable performance and limited service life. It is
recommended that you charge the scooter batteries periodically throughout periods of prolonged storage to ensure
proper performance.
You may wish to place several boards under the frame of your scooter to raise it off of the ground during periods
of prolonged storage. This takes the weight off the tires and reduces the possibility of fl at spots developing on the
areas of the tires contacting the ground.
DISPOSAL OF YOUR SCOOTER
Your scooter must be disposed of according to applicable local and national statutory regulations. Contact your local
waste disposal agency or authorized dealer for information on proper disposal of packaging, metal frame components,
plastic components, electronics, batteries, neoprene, silicone and polyurethane materials.
GT
Working Fuse
Figure 16. Fuse Replacement
Blown Fuse (Replace)
27