Proper Use And Care - Rexair Rainbow SRX Owner's Manual

Proper Use and Care

Following a few basic maintenance routines will help provide you with years of trouble-free service from your Rainbow Cleaning System. Neglecting all or part of these
instructions may lead to decreased cleaning efficiency and potentially unnecessary service expenses.
Change the water when dirty...
Do not clean too long with one filling of water. Check water
during cleaning, and if water becomes too thick with lint and
dirt, empty water basin and add fresh, clean water. For correct
water level, fill to top of post in center of water basin.
Always empty and clean the
basin...
Immediately after using the Rainbow, remove the water basin
and pour out the dirty water through the air intake opening.
Heavier particles will settle to the bottom of the basin as the
water is poured. Once water is poured, remove the remaining
heavier debris and dispose. Then wash the water basin with
soap and water. Rinse and dry thoroughly. If water basin is
stored within Rainbow unit, unit must be left in 'open' position to
allow parts to dry thoroughly.
CAUTION:
!
basin when cleaning job is finished. This helps to avoid odors,
growth of germs and bacteria and the development of water
scum in the basin. Hand wash only. Not dishwasher safe.
Always remove, empty and wash the water
Clean the separator...
For best performance, remove and clean the separator frequently.
If necessary, use the supplied Rainbow Separator Brush/Wrench to
loosen the nut. Clean the separator inside and out with soap and
water using the Rainbow Separator Brush. Clean and dry the flange
under the separator. Immediately after cleaning, dry and replace the
separator. Hand-tighten the separator nut. Do not force the separator
onto the threaded shaft.
WARNING:
!
Always replace the separator immediately
after cleaning (hand-tighten only). Do not operate the Rainbow
without the separator.
Clearing an obstruction from the hose...
If you notice decreased airflow when using the hose, the hose may
have become clogged. To clear the obstruction, turn off Rainbow
and disconnect from power source. Then, remove the exhaust
vent door on the rear of the Rainbow. Connect the hose coupling to
the exhaust air opening, making sure it is securely locked into place.
Place the hose handle wand into the air intake opening on the front
of the Rainbow. Turn the Rainbow on and jiggle the hose. Any dirt
stuck in the hose will be trapped in the Rainbow water basin.
O W N E R ' S
| 8
M A N U A L