Connections; Connecting To A Tv & Decoder - Philips DVP721VR/02 Owner's Manual

Connections

Tips
Depending on your TV and other equipment you wish to
connect, there are various ways you could connect the
unit.
Please refer to the manuals of your TV, Stereo System or
other devices as necessary to make the best connections.
For better sound reproduction, connect this unit's AUDIO
OUT jacks to the audio in jacks of your amplifier, receiver,
stereo or audio/video equipment. See "Connecting to
optional equipment" on page 11.
Caution
– Make sure this unit is connected directly to the TV. Set the
TV to the correct video input channel.
– Do not connect this unit's AUDIO OUT jack to the
phono in jack (record deck) of your audio system.
Connecting to a TV & Decoder
Make one of the following connections, depending on the
capabilities of your existing equipment.
Basic connection (AV)
1 Connect the EURO AV1 AUDIO/VIDEO on the rear
panel of this unit to the SCART input socket on the TV
using a SCART lead.
2
Some TV broadcasters transmit encoded television signals
which you can only see with a purchased or rented
decoder.You can connect such a decoder (descrambler) to
the DVD+VCR.
Basic connection (RF)
1
Connect the RF antenna cable from your indoor/ outdoor
antenna to AERIAL jack on the rear panel of this unit.
2 Connect the supplied RF antenna cable from the RF OUT
(DVD/VCR OUT) jack on the rear panel of this unit to
your television's Antenna Input.
DVD exclusive out connection
Component Video (Color Stream ® ) connection
1
Connect the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT jacks on the DVD Player to the
corresponding in jacks on the TV using the Y Pb Pr
cable.
2
Connect the Left and Right AUDIO OUT jacks of the
DVD Player to the audio left/right in jacks on the TV
using the audio cables.
S-Video connection
1 Connect the S-VIDEO OUT jack on this unit to the S-
Video input jack on the TV using the S-Video cable.
2
Connect the Left and Right AUDIO OUT jacks of the
DVD Player to the audio left/right in jacks on the TV
using the audio cables.
Progressive Scan (ColorStream ® Pro) connection
If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD Player's
progressive scan output for the highest video resolution
possible.
10
If your TV does not accept the Progressive Scan format,
the picture will appear scrambled if you try Progressive
Scan on the DVD Player.
1
Connect the COMPONENT/ PROGRESSIVE
SCAN VIDEO OUT jacks on the DVD Player to the
corresponding in jacks on the TV using the Y Pb Pr
cable.
2
Connect the Left and Right AUDIO OUT jacks of the
DVD Player to the audio left/right in jacks on the TV
using the audio cables.
Notes
– Set the Progressive to "On" on the setup menu for
progressive signal, see page 18.
– Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack) or S-VIDEO
connection.
Rear of this unit (DVD exclusive out connection)
Rear of TV
COMPONENT VIDEO INPUT/
VIDEO
AERIAL AUDIO INPUT
INPUT PROGRESSIVE SCAN
Pr Pb Y
Rear of this unit (Basic connection)
Note
– If the TV has an S-video input, connect the DVD player
with the S-video cable.When using an S-video cable, do
not connect the yellow video cable.
S-VIDEO INPUT
SCART INPUT
L R
Decoder