Better Homes and Gardens Lana Modern 3-in-1 Manual page 38

Assembly Instruction for installing the Mounting Frame onto BRICK,
SOLID CONCRETE OR CONCRETE BLOCK WALLS
NEVER use the wall anchors to mount the unit to drywall.
NOTE: If you are mounting your TV to a wall with wooden studs, skip this section. This
assembly requires an electric drill and level (not included).
47. Begin by placing the Mounting Frame (X) level against the wall where you intend to mount the
TV. Using the Mounting Frame (X) as a template, mark 4 drill points with a pencil.
48. With an electric drill (not included) on its low setting, drill 7/16 inch diameter holes to at least
2½ inch deep. Insert the Concrete Anchors (17) into the pre-drilled holes so that they are flush
with the wall.
49. Place the Mounting Frame (X) level in the desired position against the wall. Secure the
Mounting Frame (X) to the wall with the Lag Bolts (15) and the Large Flat Washers (16) at the
drill points. Tighten the bolts firmly, but be careful not to over-tighten.
2.50" (63 mm)
Maximum weight 135 lb. (61.3 kg)
Concrete Anchors should only be used for masonry mounting.
38