KEPO AC 15 Installation And Operating Manual page 33

Menu 07 - Load Initial – Turning on the pellet feeder
•
This option should be activated at the first commissioning or when there is no pellet in the tank, in which case
the NO PELLET message is shown on the display and the alarm goes off. At the first commissioning, when the
feeder is completely empty, LOAD INITIAL is turned on and the feeder starts filling. When 90 seconds run out
(the Load initial time), take pellets out of the fire pot and put them back into the pellet tank. This will make the
boiler ready for operation.
From the home screen menu, press 3 (set). Then press 5 six times. The display will look as in Figure 50.
Then press 3 (set) and change the mode by pressing 1 or 2 (Figure 51). Go back to the home screen by pressing
4 several times briefly.
Menu 08 - State Stove - The features of the current stage of boiler operation
•
This option enables you to see the stage the boiler is at (turning on, pellet burning, operation mode and
modulation) including ventilator speed, exhaust gas temperature, water temperature in the boiler, etc.
Figure 50
Figure 51
33