The machine is intended for planing of firmly Before restarting, check if the fastening supported wooden materials, such as beams and screws 12 are tightened well. Rotate the boards. It is also suitable for beveling edges and blade drum 10 by hand and ensure that the rebating.
Lock-off button for On/Off switch only low planing depths and reduce planer feed, as On/Off switch required. Screw for belt cover Excessive feed reduces the surface quality and can Belt cover lead to rapid clogging of the chip ejector. Planer base plate Only sharp blades achieve good cutting capacity and V-grooves give the machine longer life.
The values given are valid for nominal voltages [U] STAYER power tools. 230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and models for specific countries, these values can vary.
Page 9
Área Empresarial Andalucía - Sector I Calle Sierra de Cazorla nº7 C.P: 28320 Pinto (Madrid) SPAIN info@grupostayer.com www.grupostayer.com...
Need help?
Do you have a question about the P910 and is the answer not in the manual?
Questions and answers