Download Print this page

Iconasys LumiPad 360 LightBox Medium Setup Instructions

Download this manual

Iconasys LumiPad 360 LightBox – Medium: Set up Instructions

Inspect package to ensure all parts/accessories are included

*(note images included are from Small size LightBox):

A. 24 x 24" LED Backlight Panel

B. 4 x 24" LED Tower Light (2X)

C. Tower Light Power Adaptors (2X)

D. Velcro Strips (4X)

E. 1X Acrylic Shooting Stand

F. LED Photo Tent

Please

should any parts/accessories be missing

(please be sure to remove protective film)

(includes power adaptor)

Continued on page 2.

Need help?

Do you have a question about the LumiPad 360 LightBox Medium and is the answer not in the manual?

Page 1 Iconasys LumiPad 360 LightBox – Medium: Set up Instructions Inspect package to ensure all parts/accessories are included *(note images included are from Small size LightBox): A. 24 x 24” LED Backlight Panel (please be sure to remove protective film) B. 4 x 24” LED Tower Light (2X) (please be sure to remove protective film) C.
Page 2 Build light tent structure using plastic rods and connectors then place tent over top of the structure. The opening (front shooting hole) should be at the front of the studio). Light Tent Frame With Light Tent Shell on frame © Iconasys 2013-2018...
Page 3 Step 2. Attach Velcro to light panels: Step 3. Place Velcro on inside of studio in corresponding positons to Velcro on lights. © Iconasys 2013-2018...
Page 4 Step 4. Holes will need to be punctured in studio walls to run power cords/adaptors through in the following locations denoted by ‘+’ Step 5. Place light Panels inside the studio and run power cords/adaptors through holes. © Iconasys 2013-2018...
Page 5 6a. Place acrylic shooting stand inside. Note, you will want to raise this stand (we suggest >4”. In this example we use boxes to raise the stand. If using Turntable: 6b. Place turntable inside in center of the studio (and if purchased 360 acrylic riser, place on top of turntable). © Iconasys 2013-2018...