Selecting A Location - Stack-On QAS-1000 Instructions Manual

PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
● For security you must program
your own combination after opening
the safe.
● Record this new combination on
this form.
Reset Button
OPENING THE SAFE USING
YOUR COMBINATION

SELECTING A LOCATION

For best results this safe should be installed in an isolated, dry and secure area. For security the safe must be fastened to a
solid surface.
SECURING THE SAFE
Secure the safe to a permanent shelf using the holes and hardware provided.
Mark the holes to be used. Drill the appropriate diameter and depth of pilot holes depending on the type of hardware
being used and the type of mounting surface.
Secure the safe with the fasteners.
NOTE: The safe needs to be upright and right side up or the locking mechanism will not function properly.
IMPORTANT
Keep keys and your combination number in a secure place, away
from children. Keep this record of your serial number and
combination in a secure place separate from your safe. To order a
replacement key set, follow the instructions on the attached form.
Press the Reset Button (5) located inside the safe. Two "beeps" will
1.
sound.
2.
Enter your own 3-8 button combination by pressing any combination of
the 3 buttons. NOTE: A "beep" will sound when the button is
successfully pushed.
Example: (RIGHT) - (LEFT) - (CENTER) - (LEFT) - (RIGHT)
3. Press the Reset Button again. After two "beeps" your new
combination is recorded.
1. Enter your combination using the buttons. If 2 "beeps" sounds and the
green light goes on, the door will open. If an incorrect combination is
entered 4 short "beeps" will sound.
NOTE: If you enter a wrong combination 3 times, the control pad
will lock out for 5 minutes.
To close the safe, push the door closed until locked.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
2
12
40261-1101