Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Stabilizer bracket
Carriage bolt (5/16 x 3/4 inch)
Locknut (5/16 inch)
Self-tapping screw (5/16 x 3/4 inch)
Bolt (5/16 x 1 inch)
Pivot frame
Hairpin cotter
Rod
Washer
Loose Parts
1.
Remove the existing 2 bolts, 2 nuts, and hitch
bracket from the bottom of the engine guard
(Figure
1).
1. Nut
2. Existing hitch bracket
2.
Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch) as shown in
Figure 1
3. Bolt
Figure
Qty.
1
2
4
2
Use the chart below to verify that all parts have been
2
shipped.
1
2
2
2
1. Locknut (5/16 inch)
g308798
3.
Remove the existing 2 self-tapping screws from
the bottom of the machine frame
4.
Loosely install the pivot frame to the machine
frame using 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch) as shown in .
3.
2
Use
Figure 2
2. Carriage bolt (5/16 x 3/4
inch)
(Figure
g308799
4).
Advertisement
