Subscribe to Our Youtube Channel
Related Manuals for Casals DBS900
Summary of Contents for Casals DBS900
- Page 1 125mm Dual Blade Saw COMPLIES WITH M o d e l : INTERNATIONAL IEC60745 DBS900 900W SAFETY SPECIFICATIONS PLEASE READ ALL INSTRUCTIONS BEFORE USE...
- Page 2 EXPLANATION FOR SYMBOLS GENERAL SAFETY RULES WARNING! Read all instructions carefully. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warn- ings listed below refers to your mains-operated A Class II or double insulated electrical ap- (corded) power tool or battery-operated cord- pliance is one which has been designed in...
- Page 3 a power tool. Do not use a power tool does not turn it on and off. Any power while you are tired or under the influ- tool that cannot be controlled with ence of drugs, alcohol or medication. A the switch is dangerous and must be moment of inattention/distraction while repaired.
-
Page 4: Table Of Contents
Caution! Before using this product please read cling locations. this manual and all instructions and follow all its safety rules and operating instructions. Safety Instructions Instructions for tool operation. Current valid CONTENTS: regulation must be observed. Damaged or 1. Data Sheet deformed blades may NOT be used. - Page 5 the hub area with a brush or blow it clean, with an air compressor air. PREVENTION OF KICKBACK 7. The Active Guard should be retracted Kickback is the result of misuse and / or incor- manually only for making special cuts such rect product operation or conditions and can as pocket cuts and compound cuts.
-
Page 6: Datasheet
cord location during operation. Follow- The operation of any circular saw can result in ing this rule will reduce the risk of electric foreign objects being thrown into your eyes, shock or fire. which can result in severe eye damage. Before 6. - Page 7 BLADE GUARD SYSTEM Using the saw with a damaged cord could The lower blade guard, attached to your result in shocking. Have it replaced before saw, is there for your protection and safety. using the saw again. It should never be altered for any reason. If it 7.
-
Page 8: Instructions For Cross Sectional Cutting
6. INSTRUCTIONS FOR CROSS injury. SECTIONAL CUTTING REMOVING BLADES FROM SAW As everyone knows, the life span of the blade Refer to section REMOVAL OF USED TWINS and the quality of the cutting edge is depend- BLADES ent on vibrations being kept to a minimum. For this reason the material must always be ATTACHING REPLACEMENT BLADE TO clamped in place before work proceeds. - Page 9 Pipe U-section The blade is fed through the object until it reaches the lower edge, angled as it goes so that the blade hits the material at an angle of The blade is fed from corner to corner. 90°. Aluminium / copper Spiral tube and longitudinal cutting The machine must always be equipped with Feed the blade through the material, so that...
-
Page 11: Removal Of Used Twin Blades
7. REMOVAL OF USED TWIN sure they easily turn in opposite directions. BLADES 9. DUAL BLADES 1. Unplug the saw and allow blades to cool. PLEASE NOTE 2. Rotate the blades while pressing the These products are fitted with specially spindle lock down until the blades cannot designed blades for “universal”... -
Page 12: Maintenance
frequently by blowing with an air compressor. The use of attachments or accessories that are not recommended may be dangerous. LUBRICATION All of the bearing in this tool are lubricated with a sufficient amount of high-grade lubricant 11.MAINTENANCE for the life of the tool under normal operating condition. -
Page 13: Troubleshooting
12.TROUBLE SHOOTING Problem Possible Causes Solution An unusually large Damaged teeth. Replace blades amount of sparks. Feed speed is too slow. Increase feed speed Blunt teeth. Mount new set of cutter blades A lot of wear in sections. Feed speed is too fast. Reduce the feed speed Damaged teeth. - Page 14 • Casals will however replace a product, if the cost of the repair is not commercially viable or if their ability to conduct repair effectively cannot be guaranteed.
- Page 15 Be on the look-out for these Casals products at your local outlet: CD4800RE CD1200RE ID500RE ID710RE BS76-710 OS150 PL82-710 HAG2000 AG115-710 AG230-2000 JS55 R1200E CS184L...
Need help?
Do you have a question about the DBS900 and is the answer not in the manual?
Questions and answers