Related Manuals for FLIFLI Airdrop
Summary of Contents for FLIFLI Airdrop
- Page 2 Attach the bracket Attach the bracket to the leg. < FB-1000BT > Application Model : < FB-1000ST > Phantom 3 Professional, Application Model : < FB-1000AT > Advanced, Phantom 4 Series Application Model : Phantom 3 Standard ※ We highly recommend that users fasten the bracket to the landing gear with velcro included to prevent any chance for the product to disturb the sensor of your drone.
- Page 3 Attach the product Combine the bracket’s groove and the protruded part of the main product.
- Page 4 Turn on/off Double-Click the button and hold it for a while to power on. Verifying battery remains...
- Page 5 Operate Short-Press the button when product is turned on.
- Page 6 Check remaining battery To check the remaining battery, press the button when the product is turned off.
-
Page 7: Charge Battery
Charge Battery Main : Connect the charging cable to the charging socket at the bottom. Remote : Connect the charging cable to the charging socket at the side part. - Page 8 Reset When the product malfunction appears, press the reset button next to the charging socket using sharp and thin tool like clip or toothpick.
- Page 9 Synchronization To reset or to synchronize, press and hold the power buttons in both the main and the remote at the same time for more than 15 seconds. 1) LED 1-3 and 2-4 flickers in turn when the main and the remote are on standby for synchronization. 2) LED flickering will stop when synchronization is done.
- Page 10 When product does not operate well Turn the remote control ring toward the main body. Ring part of the remote has an antenna built in.
- Page 11 Attention FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two condtions: (1) This device may not cause harmful interferences, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) to this device that are not xpressly approved by the manufacturer may void the user’s authority to operate the equipment.
- Page 12 Specifications (Wireless Equipment for RFID/USN) - Operating Frequency : 917 ~ 923 MHz band use USN device - Charge Input Voltage : 5 V / 1.2 A - Operating Voltage : 3.3 V / 430 mA / 1.59 Wh / Li-Polymer Battery - Operating Temperature : -4℉...