Page 1
AirDrop has a advanced operating system and can be activated by a remote control which is included in the product package. AirDrop is designed to provide a light weight and easy-to-use dropping experience. And it is much...
Page 2
Carefully read this guide before using the AirDrop. Using the AirDrop increases the load on the drone and quickens battery drainage. AirDrop is not recommended for novice pilots or if you are inexperienced in flying Phantom series. Refrain from hanging the objects that...
Page 3
Phantom can stably carry about 300g of weight. Depending on the type of drones , the maximum load capacity may vary. (lifting force)
Page 4
If the hanging object is too light, it can be blown in the wind and makes drone operation unsafe. Remove the attached strings or adjust the length so that the object does not reach the propeller’s range.
Page 5
㎏ The pin of the AirDrop body opens up to about 1kg When hanging a heavier object, move the of weight of the load. Applying a lubricant to the center of gravity to the midpoint of the drone will reduce...
Page 6
㎏ ① If AirDrop is attached to the drone with higher lifting force, up to about 3 kg can be hung. When carrying more than 1kg of weight, the AirDrop pin will not open, but it can be used to transport the object. Lower the object until it touches the ground and open the pin.
Page 7
AirDrop guarantees a working distance of 1 km. In the distance of more than 3 km, the probability of operation will decrease.
Page 8
It doesn't disturb sight of camera installed on drone.
Page 9
Multiple AirDrops can be used at the same space. However, AirDrops will not work if more than one persons press the buttons on the remote control simultaneously. When more than one persons press the buttons on the remote control in sequence, all the AirDrops will work.
Page 10
Attach the bracket Attach the bracket to the landing gear. FB-1000GT : Phantom 4 Pro/Advanced/Pro V2.0 FB-1000BT : Phantom 3 Professional/Advanced/SE/4K ● ● FB-1000ST : Phantom 4 (Standard) only FB-1000AT : Phantom 3 Standard only ● ●...
Page 11
Attach the AirDrop body Combine the bracket’s groove and the protruded part of the AirDrop body.
Page 12
Turn on/off Slowly double-click the button and hold it for a while to power on/off. ( LED will blink when AirDrop turn on/off. )
Page 13
Slowly press button of remote control for more than 1 second. Main body and remote control send signal to each other in order to check whether AirDrop pin is closed or open. If you quickly press button of remote control repetitively, signals overlap and operation is delayed.
Built-in antenna Turn the remote control black ring toward the AirDrop body. Black ring part of the remote has an antenna built in. Wrapping antenna by hand reduces working distance.
Charging is required when the LED bar level goes down. Battery check : Press the button once in the off state. Battery operating time : 410 hours (standby), Body 2 hours and remote 3 hours (continuous movement). Turn off the power when not using AirDrop.
Press the reset button when it is not charged. Please charge at room temperature. If your country is winter, the AirDrop may be frozen during shipment. If the AirDrop is frozen, it cannot be charged. (charging with USB 5-pin cable)
Page 17
Reset When AirDrop malfunction appears, press the reset button next to the charging socket using sharp and thin tool like clip or toothpick.
Page 18
Synchronization To synchronize, press and hold the power buttons in both the body and remote at the same time for more than 15 seconds. (start with the power off) 1) LED 1-3 and 2-4 flickers in turn when the main and the remote are on standby for synchronization. 2) LED blinking will stop when synchronization is done.
◎ Do not open Sports Mode when using AirDrop. ◎ Adjust Visual Navigation System if dropping object is large. ◎ Using the AirDrop increases the load on the drone and quickens battery drainage. ◎ AirDrop is not recommended for novice pilots or if you are inexperienced in flying Phantom series.
Page 20
User's safety guideline Use AirDrop in compliance with local laws and regulations. Air drop equipment is a drone accesory product which attaches to light-weight flying drone, and we will like users to heed full attention to these prohibited acts written below.
Specifications (wireless device for RFID/USN) ◎ Size: Body 2.7 x 10.5 x 7.6 cm / Remote 2.8 x 9.5 x 2.8 cm ◎ Weight: Body: 104.9 g / Remote control: 29.8 g ◎ Operating distance: 1 to 3 km ◎ Operating frequency : 868 and 923 MHz band use USN device ◎...
Page 22
* Actual product specifications may vary, and all features, functionality and other product specifications are subject to change without notice or obligation. * FLIFLI is a registered trademark of ARBITY. Other brands and product names are trademarks or registered trademarks of their respective holders.
Page 23
For more information about AirDrop, please visit.