Advertisement
Install the door sensor
Stick the sensor on the top flap of your garage door, please make sure that the direction of
the sensor is correct.
Note:
Power on the device and check the controller's Wi-Fi indicator light after you have
installed the door sensor. It should be solid green.
If it flashes in blue, please try to control the door, the controller will link the sensor
automatically.
How to link the door sensor to the controller if the door indicator is not correct
Please set based on the controller's indicator:
If it is red, please configure the Wi-Fi connection first, then go to the next step.
If it flashes in green, please check the Wi-Fi configuration, then go to the next step.
If it is solid green, press and hold the reset button of the controller for 10 seconds
until it flashes blue, then go to the next step.
If it flashes blue, make sure that you have installed the sensor on the door correctly.
Open the door or close the door and the sensor will be paired with controller
automatically.
Note: The sensor only supports sectional doors, and does not support roller doors.
Advertisement
