Philips DVP3388K/98 User Manual page 32

[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
• [ 3D ] – select a virtual surround sound
effect that is produced from the left and
right audio channels.
• [ Movie Mode ]
for movies.
• [ Music Mode ]
for music.
[ Speaker Setup ]
When you connect a speaker system, you
can optimize surround output for the
connected speakers.
• [ Front Speaker ]
Option
[ Large ]
[ Small ]
• [ Center Speaker ] / [ Rear Speakers ]
Option
[ Large ]
[ Small ]
[ Off ]
32 EN
– select a sound effect
– select a sound effect
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
No speaker is
connected.
• [ Subwoofer ]
Option
[ On ]
[ Off ]
• [ Speakers Volume ]
level of each speaker to get the ideal
audio balance.
1. Press OK.
2. Select a speaker, then press
adjust the volume.
3. Press OK to conÀ rm and exit.
• [ Speakers Delay ]
for the center, subwoofer and rear
speakers if they are placed closer to the
listening position, so that the sound
output from all speakers reach the
listening position at the same time.
1. Press OK.
2. Select a speaker, then press
set the delay time.
3. Press OK to conÀ rm and exit.
Note
•
[ Speaker Setup ] setting is only available if you have
set the [ Analog Output ] setting to [ Multi Channel
].
Description
A subwoofer is
connected.
No subwoofer is
connected.
– Set the volume
b B to
– Set the delay time
b B to