Table of Contents
Advertisement
OCTO AV MODULATOR (REF. 8180)
1.5.
Configuring the Octo AV Modulator
N
AVIGATING THROUGH THE MENU
Use the Johansson rotary/push button to navigate through the menu. This is very
straightforward and simple. The table below shows how the rotary/push should be used:
M
ENU OVERVIEW
DISPLAY READOUT
6
Push the button 3s to enter start the
configuration
Push the button to enter the
configuration step (e.g. Region)
Rotate the button, to scroll through the
different parameters. Tap to confirm.
EXPLANATION
Stand-by mode is indicated by flashing dots on display.
Push the rotary button for 3 seconds to access the menu.
When you enter the configuration step, the LEDs of the 8
AV CHANNELS will be GREEN.
Tap to select the channel plan from your region:
UHF.E = UHF Europe
Lt1.E = UHF Europe limited to CH60 = S33 - E60
Lt2.E = UHF Europe limited to CH48 = S27 - E48
LAT.A = Latin America
When the region is updated, all 8 modulators will be set to
OFF. This way you avoid unwanted channels being
broadcasted by accident.
Tip: to switch off all modulators at once, instead of
selecting them one by one, use the region selection and
select the same region, all modulators will be OFF.
Tap to confirm.
Scroll right to go to next step.
= S38 - E69
= CH 14 – 79
Advertisement
Table of Contents
