Table of Contents
Advertisement
1
Turn on the TV to the correct viewing channel
for this product.
2
Press SETUP.
3
Press
to select [Video Setup].
4
Select [Component Video] > [Interlaced],
and then press OK.
5
Select [Progressive] > [On], and then press
OK.
»
A warning message is displayed.
6
To proceed, select [Ok] and then press OK.
»
The progressive setup is complete.
Note
•
If a blank/distorted screen is displayed, wait for
15 seconds for the auto recovery.
•
If no picture is displayed, turn off the progressive scan
mode as follows:
1) Press
to open the disc compartment.
2) Press the Numeric button '1'.
7
Press SETUP to exit the menu.
8
You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
•
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
•
To enable the EasyLink feature, you must turn on the
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press
to turn on this product.
»
The TV (if supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded in this product, disc play
automatically starts.
One-touch standby
1
Press and hold
on the remote control for
more than 3 seconds.
»
All the connected devices (if the device
supports one-touch standby) automatically
switch to standby.
Note
•
Philips does not guarantee 100% interoperability with all
HDMI CEC devices.
5 Play
Play a disc
Caution
•
Do not place any objects other than discs into the disc
compartment.
•
Do not touch the disc optical lens inside the disc
compartment.
1
Press
to open the disc compartment.
2
Insert a disc with its label facing up.
3
Press
to close the disc compartment and
start disc play.
•
To view disc play, turn on the TV to the
correct viewing channel for this product.
•
To stop disc play, press
Note
•
Check the types of discs supported (see "Your DVD
player" > "Playable media").
•
If the password entry menu is displayed, enter the
password before you can play the locked or restricted
disc (see "Adjust settings" > "Preferences" > [Parental
Control]).
•
If you pause or stop a disc, the screen saver appears after
5 minutes of inactivity. To deactivate the screen saver,
press DISC MENU.
•
After you pause or stop a disc and no button is pressed
within 15 minutes, this product automatically switches
to standby.
.
EN
9
Advertisement
Table of Contents
