Advertisement
There are a variety of ways instruments can be wired. The examples shown
here are only a few. If your instrument has different wiring than shown here
go to our website: http://www.emgpickups.com for alternate diagrams.
Diagram #2 below shows the installation of a single Volume control along with
either equalizer.
Diagram #3 shows the same installation with the Volume control following the
EQ. This is the preferred wiring order with the Volume control wired last just
before the output jack
MASTER
B30 or B64
PICKUP
VOLUME
EQ
Diagram #3
Master Volume
B30 or B64
- 9V +
PICKUP
Installation Instructions:
EMG Model: B30 or B64
2 Pickups, 2 Volume controls, B30 or 64, no selection switch
J-Bass Style wiring
Refer to Diagram #4
1) Install the Pickups and route the Pickup cables to the control cavity.
If the cables are too long, keep any excess under the pickup.
2) Mount the Volume and Tone controls into the body / pickguard.
Plug the Neck Pickup Cable onto the Neck Volume control.
Plug the Bridge Pickup Cable onto the Bridge Volume control.
3) Plug a coax cable from the Neck Volume control to the Bridge Volume
control.
4) Plug a coax cable from the Bridge Volume control to the BTS Control.
Diagram #4
Volume / Volume
B30 or B64
BRIDGE PICKUP
NECK PICKUP
B30/B64 Page 3
OUTPUT
JACK
BATTERY
BUSS
B30/B64
CONTROL
NOTE:
REVERSED
CONNECTOR!
OUTPUT CABLE
VOLUME
- 9V +
NECK
VOLUME
PICKUP
- 9V +
Diagram #2
Master Volume
B30 or B64
PICKUP
R
S
T
OUTPUT
BOTTOM
VIEW
5) Plug the output cable from the EQ Control and connect the output
wires to the output jack by pushing the connectors on as shown.
WHITE wire onto the TIP (T) contact,
BLACK wire onto the SLEEVE (S) contact
BLACK Battery Negative wire onto the RING (R) contact.
6) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud)
along with the RED of the battery clip.
Extra pins on the V+ Supply Buss are for EMG Accessories.
7) Put the battery in the insulating foam piece provided and place it securely
in the control cavity.
We suggest that you plug in the instrument and test it before closing the
control cavity.
BATTERY
BUSS
BRIDGE
VOLUME
OUTPUT CABLE
MASTER
B30 or B64
VOLUME
EQ
BATTERY
BUSS
NOTE:
REVERSED
CONNECTOR!
VOLUME
OUTPUT CABLE
B3 or B64
R
CONTROL
S
NOTE:
REVERSED
CONNECTOR!
OUTPUT
T
BOTTOM
OUTPUT
JACK
B30/B64
CONTROL
R
S
T
OUTPUT
BOTTOM
VIEW
VIEW
Advertisement
