Manual Warnings; Safety Information; Introduction - Quantum IOT Series Installation And User Instructions Manual

1

Manual Warnings

Electrical Warnings
Indicates any hazard of an electrical
nature.
Information
Indicates tips and advice for the
smooth operation of the system.
General Warnings
!
Indicates a general warning against
actions which could result in
damage to the system or personal
injury to the installer and/or user.
2

Safety Information

This appliance can be used by
!
children aged 8 years and above
and persons with reduced
physical, sensory or mental
capabilities or lack of
experience and knowledge if
they have been given
supervision or instruction
concerning use of appliance in a
safe way and understanding the
hazards involved - some parts
of this product can become hot
and cause burns. Children shall
not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
No isolating device may be
fitted between the inlet group
!
and the cold water inlet on
the cylinder, as by doing so
important safety devices
could be isolated!
The maintenance of this
appliance must be carried out
!
by suitable qualified person
only. It is recommended to
maintain the unit on an annual
basis. Isolate all electrical
supplies from the unit before
commencing work.
Danger of electrical shock!
It is important to check the
pre-charge pressure of the
!
expansion vessel membrane
before filling the cylinder.
This has been factory set to
3 bar. The pre-charge should
be greater than or equal to 3
bar.
If an electronic copy of this manual should be
required, please contact the manufacturer at the
address at the back of this manual.
For further information on product warranty
please refer to R01020-3 Terms and Conditions
Manual.
3
Thank you for choosing this product. The
Quantum direct electric cylinders are specified
with high quality, immersion heaters for fast
reheat times. They boast 60mm of low GWP
insulation foam, together with 100%
recyclable stainless steel inner components and a
sleek black, hard wearing outer shell
manufactured from completely recycled materials.
The Quantum cylinders are intended to be used
for the heating of sanitary hot water only. The
product must either operate in off peak mode with
boost/top up charging as required or it may be
operated as always on and be temperature sensor
or time clock controlled.
Dimplex cannot take responsibility for ensuring
safe operation of the appliance outside of the
scope of intended use
Note: This product has been designed
specifically for the purpose of delivering
heated, domestic and sanitary hot water as
part of a pressurised water heating system.
The package is provided with fittings that
comply with Section G3 of Building
Regulations.
Dimplex cannot take responsibility for ensuring
safe operation of the appliance outside of the
scope of intended use.
Safety Information
It is important that the tundish
is positioned away from any
electrical components.
Means for electrical
disconnection must be
incorporated in the fixed wiring
in accordance with the wiring
rules.
Before removing the cover
from the immersion heater
isolate appliance using
isolating switch!
Danger of electrical shock!
Only use suitable electrically
insulated equipment when
working inside immersion
housing.
A high level cut-out is
fitted to the product for each
heat source. This should
never activate under normal
operation.

Introduction

4