Makita DBO180 Original Instructions Manual page 7

► 1. Dust box 2. Dust nozzle
Make sure that the logo on the cardboard lip and the
logo on the dust nozzle are on the same side, then
install the dust nozzle on the dust box.
Removing dust box and paper
filter bag
1
► 1. Latch 2. Dust nozzle
Remove the dust nozzle by pushing the two latches.
Remove the paper filter bag first by pinching the logo
side of its cardboard lip, then by pulling the cardboard
lip downwards to move it out of the holding tab of the
dust box.
1
2
2
Removing and reinstalling the skirt
CAUTION:
Do not use the tool without the skirt.
Otherwise dust is scattered all over.
You can choose one of 12 directions of the skirt in
accordance with your purpose.
1
► 1. Skirt 2. Screw
To remove the skirt, remove the screw and remove the
skirt with slightly opening it for both sides.
► 1. Skirt
To reinstall the skirt, install it with slightly opening it for
both sides. And fasten the screw.
CAUTION:
Do not set the skirt other than
the designated angle. Otherwise the tool may be
damaged.
7 ENGLISH
2
1