Advertisement
Category
(choice confirmed by vibrating in
count of selected number)
1) Burst setting
2) Battery check setting
3) Fire mode setting
4) Shooting delay setting
5) Reset to default values
(returns all settings to their
default values)
Example of programming: First, I connect battery and press and hold trigger for 5 seconds. Double
vibration sounds. I press trigger 3 times and then press and hold for 5s - I'm entering Fire mode
setting. I press trigger, after every press vibrations tell me which mode I'm on. I pressed trigger 5
times, which means I choose number 5 (mode Burst only - Auto). Five vibrations sound, so I press
and hold trigger for 5s. Now double vibration sounds, which means my setting is saved and I exited
programming. My replica is ready with selected setting.
5.3. Motor vibrations meaning
•
1x vibration: each time you connect battery - states, that unit is ready
•
2x vibration: entering setting mode, saving and exiting setting mode
•
3x vibration: malfunction or damage detected
•
4x vibration: low battery detected
•
6x vibration: entering manual mode
5.4. Manual mode
If your PSJ indicates damage and you are sure it is not mechanical and your replica is able to
shoot, you can access manual mode. In this mode, malfunction is ignored and you can fire on full
auto, regardless of selected fire mode.
WARNING! By poor judgement, you can cause more damage to your replica!! This mode is not
recommended for users without advanced knowledge of AEG replicas principles!
To enter manual mode after your replica indicates malfunction, just press and holt trigger for 10
seconds. Entering is confirmed by 6 vibrations.
Value
(after you select value, confirm it by holding trigger for 5s)
Number of trigger presses = number of shots on burst
(default = 3 shots)
1) Li-pol, Li-on (default)
2) Li-Fe
3) Off (recommended for NiMH, NiCD)
1) Semi - Burst/Auto (default)
2) Semi - Auto
3) Semi - Semi
4) Semi - Burst only
5) Burst only - Auto
6) Burst only - Burst/Auto
(selection in this submenu is confirmed by vibrating in count of
selected number)
Every trigger press = +20ms
(everytime you set delay, you start from default value - for
default value, just hold trigger for 5s)
Hold trigger for 5s to confirm restart. If you do not wish to
restart your settings, disconnect your battery.
Advertisement
