Advertisement
Pict.5: Cut-off lever movement, LED indication of proper function
4.5. Trigger prepartion
Insert trigger into your gearbox and check if it goes smoothly. If not, adjust your trigger. Set the
trigger to position, where you want your replica to fire and mark the center of the probe. If you
wish your trigger to be more sensitive, use rectangular magnet and place it the way, that it is in
contact with probe until trigger fully (pict.7). If not, use round magnet. Now stick the magnet onto
the trigger, be careful about magnet polarity – black side is turned towards probe
(pict.6). If
needed, you can very gently bend the probe to be very close to magnet, but not to touch it.
Pict.6: Placing magnet onto the trigger, polarity marking, using different magnets
Advertisement
