Advertisement
Available languages
Available languages
1. Important information
Please read this manual completely and attentively before
using the product for the first time. Keep this manual. It is part
of the product.
1.1 Safety information
Caution:
Risk of injury!
Due to the detailed reproduction of the original and the
intended use, this product can have peaks, edges and
breakable parts. Tools are required for installation.
1.2 Using the product for its correct purpose
This product is intended:
-
For installation into model train layouts and dioramas.
-
For operation in dry rooms only.
Using the product for any other purpose is not approved and is
considered inappropriate. The manufacturer is not responsible
for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
-
Mast with ground socket
-
3 Pull-off pieces
-
3 Isolators
-
3 Cores
-
Screw
-
Manual
2. Mounting
1. Slide the mast off the ground socket (fig. 1).
2. Adjust the ground socket to your track system by cutting it
off with a side cutter at the respective mark (fig. 2).
3. Place the ground socket at the desired spot on your layout
and mark the screw position (fig. 3).
4. Remove the ground socket and pre-drill the determined
position with a 1 mm drill (fig. 4).
5. Put the ground socket back into its position and fasten it
with the enclosed screw (fig. 5).
6. Determine the distance between mast middle and track
middle (fig. 6).
7. Cut back the first pull-off piece to its required length. This is
the distance between mast middle and track middle, less 1
mm (fig. 7).
8. Thread the core and the isolator onto the end of the pull-off
piece (fig. 8).
9. Bend the end of the pull-off piece at a length of 3 mm by
90° using bending tongs item 4198 (fig. 9).
10. The length of the second pull-off piece results from the
existing track middle radius plus an addition of 26 mm
(fig. 10).
11. Now thread the core and the isolator onto the second
pull-off piece (fig. 11).
12. Then bend the end of the second pull-off piece at a length
of 3 mm by 90° using bending tongs item 4198 (fig. 12).
13. Now clip the complete set of pull-off pieces into the appro-
priate mast opening (fig. 13).
14. Finally, slide the mast back onto the ground socket (fig.
14).
4
EN
Advertisement
