Table of Contents
Advertisement
A
Inserting and Removing Modules
Caution
To prevent ESD damage to electronic components, always use an ESD wrist
strap when handling modules or coming into contact with internal components.
Inserting a module into the chassis
1
Align the edges of the module with the card guides on each side of the slot (see figure).
2
Ensure that the ejector levers are in the out position. Keeping the module horizontal, slide
the module into the slot until the ejector levers contact the chassis.
3
Push both ejector levers in simultaneously to seat the module in the backplane connector.
4
Tighten the captive screws with a flat-blade screwdriver.
1
2
Insert card
between card guides
Captive installation screw
Removing a module from the chassis
1
Loosen the captive screws on the module using a flat-blade screwdriver.
2
Pull the ejector levers outward simultaneously to release the module from the backplane
connector.
3
Pull the module straight out of the slot and place it on an antistatic mat or in an antistatic
bag.
CAUTION:
This unit
has more
than one
power-
supply
cord.
To reduce
the risk
of electric
shock,
disconnect
both
power-
supply
cords
before
servicing.
Ejector lever
CAUTION
THIS ASSEMBLY
CONTAINS
ELECTROSTATIC-
SENSITIVE DEVICES
11
Advertisement
Table of Contents
