Advertisement
POWER SUPPLY
The power supply required for the actuator will depend on the Actuator, please read the label on the
Actuator for the recomended voltage.
FUSE
It is recomended that an inline fuse be fitted, please use a fuse that is 10% higher (oras close as
possible) than the Max current rated on the Actuator label.
E.g. Use a 3.2A fuse for a 3A Actuator.
BASIC WIRING DIAGRAM
Motor (Actuator)
Digital Encoder Output
Pulse
+5v
Earth
White
Red
Black
Green
Yellow
#
Colour
1
Yellow
2
Red
3
White
4
Black
Hall effect Ground (OPTIONAL)
5
Green
6
Blue
1
5
4
6
3
Function
Motor +/-
Hall affect 5V (OPTIONAL)
Hall effect 1 (OPTIONAL)
Motor –/+
Hall effect 2 (OPTIONAL)
WIRING TO TECHOME'S MOTOR CONTROLLERS
SWITCH
In the example diagram, the switch is a 3 position
switch on/off/on. This will allow you to move the
1
Actuator in, stop the Actuator (middle position) and
move the Actuator out.
2
Please ensure the switch
current rating exceeds
Hall Affect
the Max current stated on the
(Not in use)
actuator label.
ACTUATOR MOUNTING OPTIONS
2
Power supply
DPDT Switch Centre Off
Eg: Jaycar Electronics
PN SK0980
GOOD
GOOD
BAD
GOOD
Fuse
View from back
of switch
Yellow wire
Green wire
Red, white and black
wires not used
GOOD
Advertisement
