Venture Products Ventrac SS300 Operator's Manual & Parts Drawings page 16

SPREADER SETUP & INSTALL KITS
8. Insert the spreader hitch into the power unit's
receiver hitch tube and fasten with a 5/8" x 3"
clevis pin and a 1/8" x 2-1/2" hairpin.
CAUTION
If the power unit is equipped with a 3 point hitch,
adjust the lift arm links to position the lift arms
in the outermost position to prevent damage to
spreader if 3 point lift arms are raised accidentally.
Control Box Setup
1. Fasten the controller bracket (A) to the control
box mount bracket (B) using 2) #10-32 x 1/2"
machine screws and #10-32 flange nuts.
B B
2. Place the nylon washers on the inside of the
controller bracket and install onto the controller
using the 1/4" bolts and flat washers. Tighten the
bolts until the controller pivots with resistance.
A A
Power Unit Without Cab
(If power unit is equipped with cab, skip to next section)
1. Insert the tabs of the frame clamp bracket into
the slots of the frame mount bracket and fasten
with 3/8"x 2" carriage bolts and knobs.
2. Place the frame mount bracket against the inside
of the right leg of the roll bar. Position the bot-
tom edge of the frame mount bracket 24 -25
inches from the bottom of the roll bar and install
2) u-bolts and 4) locking flange nuts. Torque the
flange nuts to 31 ft-lbs (42 Nm).
3. Insert the arm of the control box mount into the
frame clamp bracket.
Setup - 16