Specifications; Safety Instructions - Makita MLT100 Instruction Manual

ENGLISH (Original instructions)
1. Hole diameter 8 mm
2. 6 mm std. washer
3. No. 10 wood screw 40 mm min.
length
4. 6 mm Mounting bolt & Nut tighten
securely
5. Push stick
6. Rip fence (Guide rule)
7. Miter gauge
8. Handle
9. Arrow pointer
10. Lock lever
11. 90° adjusting screw
12. 45° adjusting screw
13. Switch
14. Restart button
15. Screws
16. Sub table (R)

SPECIFICATIONS

Model
Arbor hole
Blade diameter
Blade body thickness
90°
Max. cutting
capacities
45°
-1
No load speed (min
Table size (L x W)
Dimensions (L x W x H)
with table(s) not extended
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
.................. Do not place hand or fingers close to
the blade.
Intended use
The tool is intended for cutting in wood.
8
Explanation of general view
17. Sub table (back)
18. Slide table
19. Locking plate
20. Wrench
21. Hex nut
22. Inner flange
23. Ring
24. Saw blade
25. Outer flange
26. Blade guard
27. Riving knife
28. Blade guard mounting portion
(stay)
29. Blade
30. These two clearances should be
equal.
31. Hex bolts (A)
32. Hex bolts (B)
(for European countries)
260 mm
)
(685 mm - 835 mm) x (955 mm - 1,305 mm)
with sub tables (R) and (back)
726 mm x 984 mm x 333 mm
with sub tables (R) and (back)
MLT100
30 mm
1.9 mm or less
93 mm
64 mm
34.1 kg
END215-6
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.

SAFETY INSTRUCTIONS

WARNING! When using electric tools, basic
safety precautions, including the following, should
always be followed to reduce the risk of fire, electric
shock and personal injury. Read all these instructions
before operating this product and save these
instructions.
For safe operations:
ENE003-1
1. Keep work area clean.
33. Lever
34. Scale
35. Hex bolts
36. Guideline
37. Screw
38. Face/edge parallel
39. Wood screw
40. Glue together
41. Auxiliary fence
42. Push block
43. Cross cutting
44. Mitering
45. Bevel cutting
46. Compound mitering (angles)
47. Knob
48. Brush holder cap
49. Screwdriver
(for other than European countries)
25 mm and 25.4 mm
255 mm
90.5 mm
63 mm
4,300
(685 mm - 835 mm) x (955 mm - 1,305 mm)
with sub tables (R) and (back)
726 mm x 984 mm x 333 mm
with sub tables (R) and (back)
34.1 kg
/II
ENF002-2
ENA001-2