Commodore CDTV/P Manual page 17

2-8 Setting Up Your CDTVIP System
Connection for a Monitor or Monitor-Style Television Set
To connect the CDTV IP sound to a stereo monitor or monitor-
style stereo television set, insert one end of the stereo cables
into the right and left audio outputs on the back of the
CDTV IP. Then insert the other ends into the corresponding
audio inputs of the monitor or TV.
If your monitor or TV has only a monophonic speaker, you can
convert the two stereo channels from the CDTV IP to a single
channel that can be plugged into any monophonic audio input
by using an optional cable called a "Y" adapter. This adapter
can be purchased at electronics stores and in the electronics or
hardware departments of many large consumer stores. Just
insert the two phono plugs at one end of the "Y" adapter into
the two audio outputs on the back of the CDTV /P. Then insert
the single plug at the other end of the "Y" into audio input jack
of the monitor or TV.
Connection for a Stereo System
If your stereo system has a set of RCA-type audio input
connectors (labeled Auxiliary, Aux, CD, Tape, VCR Audio,
TV/Aux, etc.), you can use these connectors to attach the
stereo output cables from the CDTV IP.
To connect the CDTV IP to your stereo system, insert the
cables into the right and left audio output connectors of the
CDTV IP. Then insert the other ends of the cables into the
corresponding audio input jacks of the stereo system.
If you have a non-standard (i.e., non-RCA) type of connector on
your stereo equipment, there is probably an adapter that will
enable you to make the audio connection. See your dealer for
information.