Installation; Usage - Duramaxx 10029319 Manual

1. Put the cylinder into the gas heater.
2. Install the protection baffle to make sure the cylinder cant' move.
3. Connect the pipe to the gas valve with cap (make sure no leakage).
4. Connect another side of the pipe to the regulator with cap (make sure no leakage).
5. Open the gas tap before using the heater, and close the gas tap after using.
Lighting heater
Before connecting the regulator to the gas cylinder, check whether there is a rubber
washer on the regulator, and the washer must be in good condition. Connect the regula-
tor to the gas cylinder by turning the hand wheel anticlockwise. Open the gas cylinder by
turning the gas cylinder valve anticlockwise. Turn the gas control knob on the heater to
setting 1(fig 4).
Press the control knob down and hold in the pressed condition. This will allow gas to flow
to the pilot and centre burner. While holding the control knob in the pressed position, push
the piezoelectric ignition button 2 or 3 times. Each time you strike this piezoelectric igni-
tion you will hear a clicking sound as well as see a spark on the pilot burner. Once the pilot
has lit, continue holding the gas control knob in the pressed position for a further 10 to 15
seconds thus activating the flame failure safety device.
The pilot and centre burner should remain alight. You may now adjust the heater setting
to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position 1 and close the gas cylinder valve
by turning the knob on the cylinder clockwise. Ensure that the pilot flame the centre
burner are extinguished.
Testing gas leaks:
When you suspect that the heater is leaking, turn off the gas supply and have the unit
inspected by a qualified technician. Do not attempt to locate the source of leak with a na-
ked flame. Locate it by sound, smell or by applying soapy water. Any bubbles forming will
indicate the whereabouts of a leak.
In event of leakage, the appliance should be turned off at the regulator switch-on valve
and the regulator disconnected from the cylinder.
How to change a cylinder
1. Turn off at the regulator and allow the heater to cool fully before removing and replac-

Installation

Usage

11