Summary of Contents for Redback 1L360R+
-
Page 2: Operating Instructions
Follow relevant Australian Standards Copyright © CMI LasersTM RedBack lasersTM and Level1LasersTM . All rights reserved CMI Industries Pty Ltd 2016 No artwork or photographs produced by CMI Industries Pty Ltd may be used copied or reproduced without the written consent... - Page 3 1L360 INTRODUCTION Congratulations on purchasing one of the RedBack 1L360R™ Auto Levelling 360 horizontal line lasers. The 1L360R comes in a number of different kits but the laser itself is the same in all. Please note that some of the accessories described in this manual may not be included in the particular kit you have purchased.
- Page 4 1L360R DIAGRAMS 1L360R Laser Level 1. Laser Output Windows 2. Control Keypad 3. Pendulum Locking Knob 4. Battery Compartment 5. Tripod/Mounting Threads 5/8”, 1/4”...
- Page 5 Keypad Pulse Mode LED Manual Mode LED Pulse Mode Manual Mode Function Button Function Button Power LED 1L360R+P kit with receiver, Tripod & Staff www.redbacklasers.com.au...
- Page 6 1L360R OPERATING INSTRUCTIONS Battery Instructions The 1L360R has two battery options either 4 x standard “AA” size Alkaline or the Li-ion rechargeable pack. For standard 4 x “AA” alkaline operation simply insert “AA” batteries into standard battery holder in the direction indicated and slide the holder into battery recess and close the battery compartment cover.
- Page 7 1L360R OPERATING INSTRUCTIONS cont. Turning On the 1L360R To power up, simply unlock the pendulum by moving it to the “ON” position, this will automatically self level the laser and power up the horizontal beam. If when you unlock the pendulum the laser beam flashes and a beeping sound is emitted then the laser is out of self levelling range, place the laser on a more level surface for the device to self level and power up.
- Page 8 1L360R OPERATING INSTRUCTIONS cont. Pulse Mode Pulse mode allows the 1L360R to be used with the LLR705 line receiver and so allowing the laser to be used outside for general site levelling, patios, decking etc. With the 1L360R, pulse mode is automatically enable when powered up. For maximum visible brightness indoors disable the pulse mode by pressing the pulse “P”...
- Page 9 Laser Receiver LLR705 (Supplied with 1L360R+ and 1L360R+P kits) The RedBack LLR705 allows the laser beam to be picked up outside at up to 150m radius in any lighting conditions. Ideal for decking, sheds, slabs, framing and much more. The receiver can be used hand held or together with the staff clamp with a staff.
-
Page 10: Manual Mode
1L360R OPERATING INSTRUCTIONS cont. Manual Mode Manual mode allows you to turn on the 360 degree line with the pendulum in the locked position and so allows you to set up a laser line at an angle such as for installing balustrades. Manual mode is activated by pressing the manual mode left button when the pendulum is in the locked “OFF”... -
Page 11: Technical Specifications
IP Dust Water Resistance IP55 Power 4 x “AA” Alkaline or Li-ion pack Low Power Power LED Flash Size 132x122x75mm Weight 1.0Kg Range with Receiver as tested with RedBack LLR705 receiver, range may vary depending on type of line receiver used. www.redbacklasers.com.au... - Page 12 (03) 5240 3999 “You” or “Consumer” refers to the initial purchaser of the product. “Product” refers to goods manufactured by or for CMI Industries Pty Ltd under the brands of RedBack Lasers, Level1Laser and CMI Lasers. “Material” refers to material or component used in the construction and manufacture of the product.