Advertisement
Installation Instructions
6. Press-fit the four stand-off
spacers (6) supplied into the
matching holes (9) of the control
panel (10).
7. Carefully position the receiver
board (5) over the 3- and 4-pin
headers (7 and 8). Apply
downward pressure to snap the
tops of the four spacers (6) onto
the receiver board
8. Loosen both screws on the
receiver board (5) antenna block.
9. Insert ground lug (12) into the
left-hand terminal of the
receiver board antenna block
and secure lug to the enclosure
using the self-tapping screw (13)
provided.
10. Insert the antenna (14) into the
right-hand terminal of the
receiver board antenna block.
11. Secure the ground lug (12) and
antenna (14) by tightening both
screws on the receiver board
antenna block.
12. Reinstall enclosure door
removed in step 1.
Specifications:
Physical:
Electrical:
Wiring:
Signal from Panel Antenna
¬1 l
N9931 6/00
2-3/8" W x 1-11/16" H x 5/8" D (50.mm x 43mm x 16mm)
Voltage Input: 5VDC; Current Drain: 32mA
As indicated in table:
3-PIN HEADER
Gnd
Gnd
Subsidiary of PITTWAY CORPORATION
149 Eileen Way, Syosset, New York 11791
Copyright © 2000 PITTWAY CORPORATION
14
13
12
8
7
6
P / O
L
R O
N T
L
C O
N E
P A
4-PIN HEADER
5VDC
Clock
Data
Gnd
IMPORTANT!
For best possible
performance of the
Receiver, it is extremely
important to be sure that
the ground lug connection
is solid to both the
enclosure and to the
antenna block.
11
A
10
9
5
4 0 1
Z R
ZR401-02-V0
ANTENNA BLOCK
Gnd
Antenna
Advertisement
