iData 95 Troubleshooting

iData 95 Troubleshooting
Table 1 iData 95 Troubleshooting
Fault
After the power
key is pressed, the
iData 95 is not
powered on.
Battery charging
fails.
During data
communication,
data is not
transmitted or
transmitted data is
incomplete.
The relevant
function is not
activated after a
user clicks a button
or icon.
No sound can be
heard.
The iData 95 is
closed.
The iData 95
responds at a low
speed.
The iData 95 does
not decode
barcodes.
Cause
The battery volume is too
low or the battery is not
charged.
The battery is incorrectly
installed.
The system breaks down. Restore factory settings.
The battery fails.
The temperature of the
battery is too high or low.
The cable configuration is
incorrect.
The communication
software is incorrectly
installed or configured.
The system does not
respond.
The volume is too low or
is disabled.
The iData 95 is in the
inactive state.
The battery is used up.
Too many files are stored
in the iData 95.
Too many applications
are installed on the iData
95.
The scan application is
not loaded.
Reading a barcode fails.
The battery volume is
low.
Solution
Charge the iData 95 or replace the
battery.
Correctly install the battery.
Replace the battery.
Put the battery in normal temperature.
Consult the system administrator.
Install or reinstall the ActiveSync
software to update the driver.
Restart the system.
Adjust the volume.
After being inactive for a period of
time, the iData 95 is closed.
Replace the battery.
Remove unused memos and records.
If necessary, save the records on the
host or increase the storage capacity
by using an SD card.
Remove applications installed on the
iData 95.
Load iScan in the iData 95.
You can download iScan here:
http://t.cn/8k5hWCo
Check that the barcode is defective.
If the scanner stops sending out laser
beam after you turn on the switch,