Advertisement
Dimension
Installation
1: Fit the O-ring into the groove at the underside of the mixer body.
2: Screw the flexible hoses into the mixer body, and fully hand tighten.
3: Pass the tail of flexible pipes through the hole on the basin from above, and place the mixer in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the plastic washer from the under-side of the counter.
5: Check that the mixer body is correctly positioned, fully tighten the ffixing nut.
6:
Connect the water supply pipes to the tail of flexible hoses with the hot water and cold water.
217
MIXER BODY
HOSE
PLASTIC WASHER
FIXING NUT
2 - 2
109
MIXER BODY
RETAINING
NUT
CARTRIDGE
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
HANDLE
GRUB
CARTRIDGE
SCREW
COVER
CAP
ALLEN
KEY
A
Advertisement
