Table of Contents
Advertisement
6
Select [Progressive] > [On] , then press
OK .
A warning message is displayed.
»
7
To proceed, select [Ok] and press OK .
The progressive setup is complete.
»
Note
•
If a blank/distorted screen is displayed, wait for
15 seconds for the auto recover.
•
If no picture displayed, turn off the progressive
scan mode as follows: 1) Press to open
the disc compartment. 2) Press . 3) Press
AUDIO SYNC .
8
SETUP to exit the menu.
Press
9
You can now turn on the progressive scan
mode on the TV.
Note
•
During play, when progressive scan mode is on
for both this Home Theater System and the
TV, distorted picture may display. Turn off the
progressive scan feature on both this Home
Theater System and the TV.
16
EN
Change speaker settings
Ideally, the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position to obtain
the best possible surround sound.
Audio Setup
Speakers Volume
Speakers Delay
Night Mode
CD Upsampling
1
Press DISC .
2
SETUP .
Press
3
to select [Audio Setup] in the
Press
menu, then press .
•
If the speaker setup option is not
accessible, press
try the above steps again.
To set the speakers level
1
Select [Speakers Volume] in the menu,
then press .
Speakers Volume Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
twice before you
0dB
0dB
0dB
0dB
0dB
0dB
Advertisement
Table of Contents
