LG UT64 Series Installation Manual page 29

» Type of Connector: D-Sub 9-Pin Male
No.
1
2
3
4
5
6, 8
7
9
One Channel Map
(Depending on model)
• If set to 'Enable' , the TV will operate as below.
- A. When the TV is auto-scanning, it searches both air and cable channels.
- B. User can assign a channel number him/herself by manual scan.
- C. In 'Channel Edit' window, all channels are shown in a single list regardless of input source.
- D. Automatically scanned channels may not have the user-desired channel numbers.
• If user change the 'Enable/Disable' value, an pop-up window will be displayed to warn that all channel will be deleted. The Default value is
'Enable' .
DTV Channel Update
• It is a mode to set whether to update DTV Channel automatically or not.
• When set to 'Auto' , the function to update TV's Channel map according to DTV Channel's stream information.
• When set to 'Manual' , the function to keep TV's Channel map even though DTV Channel's information is changed.
On Timer Operation
• It is a mode to select 'Timer Power On' working one time or repeatedly.
• 'Once': 'Timer Power On' in the user menu operates only one time when the Timer Power On menu is set to On.
• 'Repeat' : 'Timer Power On' operates repeatedly when the Timer Power On menu is set to On.
USB Auto Playback
(Depending on model)
• When 'USB Auto Playback' is set to 'Movie' , TV finds and plays the USB's movie files located at the root(top) directory Movies if USB is plugged in.
• When 'USB Auto Playback' is set to 'Photo' , TV finds and plays the USB's photo files located at the root(top) directory Photos if USB is plugged in.
• If it reaches the last file, it starts the first file again
Male connector on box, viewed towards connector.
Signal
VCC
RX RS232
TX RS232
IR from TV
GND
Not connected
2 A
1.5 A
Signal requirements
Standard RS232 specification
Standard RS232 specification
Power ground
+5 V DC 10 %, max 100 mV ripple
+12 V DC 10 %, max 100 mV ripple
29