Advertisement
4. ASSEMBLY & OPERATION
WARNING! Ensure that you read, understand and apply safety instructions before use.
4.1.
Assembly
4.1.1. Open front paper clamp and insert the end of the sanding paper. Release clamp lever to hold paper in
place. Repeat with rear clamp, ensuring that the sanding paper is tight against the sanding pad.
4.1.2. Connect air supply to sander, press the trigger and check that the sander is working correctly.
4.2.
Operation
4.2.1. Always use a sanding paper appropriate for the job. Work progressively from coarse grades to finer
grades. DO NOT go from coarse to fine in one step as it may be difficult to remove swirl marks left by
the coarse grit.
4.2.2. DO NOT apply excessive pressure, let the sander do the work for you. Start the sander and bring it to
the work surface evenly and slowly. Move the sander back and forth in overlapping areas. Remove the
sander from the work surface before stopping the sander. Regularly check the sanding paper for wear
and always change if cracked or damaged.
4.2.3. DO NOT allow sander to run in "idle" for an extended period of time as this will shorten bearing life.
5. MAINTENANCE
WARNING! Disconnect sander from air supply before changing accessories, servicing or performing
maintenance. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
5.1.
If the air supply does not have an oiler, lubricate the sander daily with a few drops of good grade air tool
oil, such as Sealey ATO/500 or ATO/1000, dripped into the air inlet before use.
5.2.
Clean the sander after use and change pads when required.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose
connectors. To remedy check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the sander may also reduce performance. If your model has an air strainer
(located in the area of the air inlet), remove the strainer and clean it. Flush the sander with gum
solvent oil or an equal mixture of SAE 10 oil and kerosene. Allow to dry before use.
If you continue to experience problems, contact your local Sealey service agent.
5.4.
When not in use, disconnect sander from the air supply, clean and store in a safe, dry, childproof
location.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
©
Jack Sealey Limited
Environmental Protection.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
Web
01284 703534
email
SA22.V3
www.sealey.co.uk
sales@sealey.co.uk
Issue: 5(SP) 05/01/14
Advertisement
