Advertisement
2. INTRODUCTION
Portable rechargeable floodlight in die-cast aluminium housing with tubular steel framed stand. Features super bright 10W COB
LED and built-in Lithium-ion battery. Supplied with mains adaptor and car charger.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . LED110C
Battery: . . . . . . . . . . . 7.4V 2Ah Li-ion Rechargeable
Lumen Output: . . . . . . . . . . . . . . . . . . . . . . . . 650lm
4. OPERATION
4.1. OPERATION
WARNING! Ensure that you read, and fully understand the safety instructions before use.
4.1.1. Charge the batteries before use.
IMPORTANT: Ensure the floodlight is turned 'Off' whilst charging. Failure to do so will damage the charger plug/vehicle
plug.
4.1.2. Turn floodlight 'On' and 'Off' by the plunger switch (fig.1.A) on the main body.
4.1.3. The position of the main body can altered by loosening the screws (fig.1.B) and moving the main body.
4.2. BATTERY CHARGING
WARNING! Ensure that you read, fully understand, and apply the safety instructions relating to the battery and charger
before use.
4.3. MAINS CHARGER PLUG
4.3.1. Ensure the floodlight is turned 'Off' and then plug the charger adaptor into the jack inlet (fig.1.C) next to the on/off switch.
Stand the floodlight in a safe location ready to charge.
4.3.2. Plug charger into the mains supply.
4.3.3. Allow approximately 5hours for the initial charge and for susequent charges.
4.3.4. When full charge has been reached, switch off the mains supply and unplug the charger from the mains and then from
the floodlight. The floodlight is now ready for use.
4.3.5. Store the charger in a safe, dry location.
Notes: a) Fully charged batteries will last for approximately 2hours.
b) DO NOT fully discharge the batteries before recharging.
c) DO NOT leave batteries in a discharged state, recharge batteries immediately. If the floodlight is not in use, recharge
the batteries every three months.
4.4. VEHICLE CHARGER PLUG
4.4.1. Ensure the floodlight is turned 'Off' and then plug the vehicle charger plug into the jack inlet (fig.1.C) on the floodlight body.
Stand the floodlight in a safe location ready to charge.
4.4.2. Insert the charger plug into the vehicle's accessory socket (12V only).
4.4.3. Allow approximately 5hours for the initial charge and for subsequent charges.
4.4.4. When full charge has been reached, unplug the adaptor from the vehicle's accessory socket and then from the floodlight.
The floodlight is now ready for use.
4.4.5. Store the charger plug adaptor in a safe, dry location.
NOTE: Charging the floodlight from a 12V vehicle socket will drain the vehicle's battery, unless the engine is running.
NOTE: The Li-ion battery does not suffer from memory effect and once fully charged the floodlight may be stored for up to 6
months before recharging is required.
© Jack Sealey Limited
Operating Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2hrs
Charging Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5hrs
Original Language Version
fig.1
LED110C
Issue: 1 - 11/04/14
Advertisement
