Advertisement
6 6
STEP 6. Turn the workbench upside down and screw in the corner
braces (O) as shown in the diagram. At each corner attach
the leg levellers (T). Slide the workbench top (P) under the
main unit and fix with 4 hex head screws (U)
8
STEP 8. Pull the middle slide and the ball bearings out as far as possible. Hold the drawer and slot the inner slide on the drawer into the middle slide,
then push the drawer all the way in. take the shelves (K) and slot them into the support panels at the height required.
To remove drawer see Step 2.
7
STEP 7. Attach the inner slides onto the drawers. Slot the
horizontal tab into the hole in the drawer and the vertical
tab into the other hole. Push down until the stop slots
into the small hole.
AP2030BB - 1 - 260407
Advertisement
