Maintenance - Markerry MK02-HMCVWD-PKA Owner's Manual

Cleaning:
Note: ALWAYS unplug the humidifier from the electrical outlet
before cleaning. NEVER allow water to sit in the tank when
not in use.
Cleaning the Water Tank -
Fill the Water Tank with a mixture of one (1) litre of water and
eight (8) ounces of white vinegar. Leave the mixture in the
Water Tank for 20 minutes, giving the Water Tank a shake
every few minutes. After 20 minutes, give the Water Tank a
final shake and discard the mixture.
Cleaning the Water Basin -
Dampen a cloth with a solution of vinegar and water, Wipe
down the Water Basin (P5) with' the damp cloth. Rinse with
cool water. DO NOT IMMERSE the Water Basin or hold
Nebulizer (P5) directly under the water tap.
Cleaning the Base -
Wipe all exteriors surfaces of the Base (P5) with a soft, dry
cloth. Do not immerse the Base in water or use water to clean
the Base. As with any electrical appliance, an electrical shock
may result or the humyidifier may be damaged.
Cleaning the Nebulizer -
There may be some lime deposits in the Nebulizer (P5),
particularly in areas with hard water. Overcome this by
cleaning the Nebulizer with water and vinegar on a soft cloth
regularly as follows:
Dampen a cloth with vinegar and wipe the Nebulizer
•
gently, until the lime deposits disappear completely.
Gently clean with a dry cloth and remove the residue from
•
the nebulizer.
Cleaning the Fan Vent -
lt's important that the Fan Vent area (P6) is kept clean and
free of obstructions. Simply wipe the Fan Vent with a clean,
dry cloth. Avoid setting the humidifier on a towel or carpeted
surface as the Fan Vent may become blocked and cause the
unit to overheat.
Cleaning the Water Level Sensor -
The Water Lever Sensor is made up of Plastic Cap, the Water
Float, and the Pin. Wipe the parts with a soft damp cloth. (P7)

Maintenance

Essential oils
Water
Basin
Nebulizer
Water
Level Sensor
P5
Fan Vent
P6
Plastic Cap
Pin
Water Float
P7
5