Maintenance - Eastwood L6700 Instructions Manual

ADJUST FIT OF HELMET:
Headband – Push Knob in and Turn Clockwise to decrease size (tighten) or rotate Counter-Clockwise
to increase size (loosen).
Width/Height – Push in rectangular latch on the two overhead bands, slide bands in to shorten band
or pull out to lengthen bands. Snap button into the nearest available rectangular holes.
Flip-up Retention – This will allow the helmet to stay in the "flipped-up" position. Tighten or loosen
knobs on either side of the helmet to increase or decrease friction.

MAINTENANCE

• The Red LED "Low-Bat" Lamp is located on the upper, inner panel above the viewing area to
the right of the Control Knobs (FIG 1). If it is illuminated, the batteries may require a charge by
exposing the face of the Welding Helmet to bright sunlight for several hours. If this fails to extin-
guish the light, the batteries will require replacement. If this becomes necessary, replace with
two 3V type CR2450 by following the "Replace Batteries" section below.
REPLACE BATTERIES:
- Note location on panel of view frame inside
of Helmet, press in and down on raised ribs
of Battery Covers to unlatch and remove Covers
(FIG 3).
- Remove Batteries.
- Replace Batteries with 3V type CR2450
with positive side facing upward.
- Replace Battery Covers and snap back into place.
• Clean outside and inside of lens with a soft cloth and
small amount of glass cleaner. NOTE: Do not use excessive glass cleaner or allow the lens
assembly to become wet or the sensitive electronics will be destroyed. Never use solvents.
• Clean headband with a cloth dampened with mild soap and water. Allow to dry thoroughly.
• Check lens assembly for damage before each use. If cracked or broken, DO NOT USE.
REPLACE OUTER SHIELD:
- Insert tip of the forefinger into the semi-circular
recess at the bottom of the viewing area, pry the
Lens up while curling it outward in the center,
then out and away from Helmet (FIG 4).
- Reverse to install by squeezing sides to curl
the center outward then insert edges into
channels around frame of opening (FIG 4).
6
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 3
Open
FIG. 4
Batteries