Table of Contents
Advertisement
二、 Cleaning and Maintaining
Although we have already strength the credibility of the product in design, we always continue to
keep the high level of quality and try our best to extend the lifetime of the product. We should
maintain the product regularly and confirm the light to show itself under the best situation, and it is
necessary.
I、 The cleaning of the fixture.
II、 The cleaning maintaining of the lens
In order to confirm the optimum effect of the fixture, please clean each lens or the reflecting
configuration. Please use the soft cotton cloth with little lotion to clean lens and protect the lens from
damage.
III、The regular check of the cables
Check the connecting cable, cloth cable and ground cable and confirm the security of the fixture foe
using.
Check if it is the master mode
The installation of the address
code is wrong
There is a piece of fixture whose
connector can not work normally
The signal output of the controller
is not matched with the connector
of the signal receiving(PINS2—3
is wrong)
Page
32
of 36
It is installed the slave mode
under the DMX mode
Check the address code and
install them totally
After drawing the signal cable
input and output out of the
fixture and connect each other
directly, then check if there is a
problem with the fixture. If it can
work after connecting, it proves
that there is a problem with the
signal connector of the fixture.
According to the way--- trouble
shooting, then select the broken
fixture and ask the professional
to repair.
Dial the polarity switch of the
controller to"PHASE", and
exchange the address of
PIN2—3
Advertisement
Table of Contents
