Table of Contents
Advertisement
Available languages
Available languages
Set/Change code
The Child lock feature (see TV, Features, p. 13)
allows you to lock channels to prevent others from
watching certain programmes.To watch locked
channels, a 4-digit code must be entered.The
Set/Change code menu item allows you to create
or change a Personal Identification Number (PIN).
&
Select
Set/Change code
é
If no code exists yet, the menu item is set to
. If a code has previously been
Set code
entered, the menu item is set to
Follow the instructions on screen.
Source
Source
Setup
This menu allows you to indicate the peripheral
you connected to one of the external inputs.
&
Press the cursor right to enter the list of types
of peripherals attached to the selected input.
é
Select the peripheral device with the cursor
up/down.
Once you have selected the source type, e.g. DVD,
this source will automatically be selected when
your remote control is in DVD mode, see p. 3, and
when you press the v key on the remote
control.
Decoder
Setup
.
Change code
EXT1
EXT2
EXT3
EXT4
SIDE
Centre input
Centre in vol.
Decoder
Programme
Status
Important:You have forgotten your code !
&
Select
Change cod
press
.
OK
é
Press the cursor right and enter the overriding
code 8-8-8-8.
"
Press the cursor again and enter a new
personal 4-digit code.The previous code is
erased and the new code is stored.
.
Centre input - Centre in volume
When you have connected a surround receiver
to the TV see p. 24, the loudspeakers of the TV
can act as centre speaker, making a separate
centre speaker unnecessary.
Select
Centre input On
(in case you have connected a Cinema Link
surround receiver).
When having selected
Centre in volume with the cursor left/right to
correct volume level differences of the external
audio receiver and speakers.
Note: This is not the case with a Cinema Link
surround receiver.
If a decoder or a descrambler is connected, see
p. 22, you can define one or more programme
numbers as decoder programme numbers.
&
Select
Decoder
é
Select
Programme
"
Select the programme number under which
you have stored the programme coming from
your decoder.
'
Select
Status
• Select the input used to connect your decoder:
,
None
EXT1
• Select
None
programme number being activated as a
decoder programme number.
Note: Select
EXT2
to your EasyLink video recorder.
e in the General menu and
or
Cinema Link
On
you can adjust the
with the cursor right.
.
.
or
.
EXT2
if you do not want the selected
when the decoder is connected
.
9
Advertisement
Chapters
Table of Contents
