Panasonic CF-H2 Series Operating Instructions Manual page 30

Troubleshooting (Basic)
■
Starting Up
The date and time are
incorrect.
Windows startup and
operation is slow.
[Executing Battery
Recalibration] screen
appears.
[Enter Password] does not
appear when resuming
from sleep (
hibernation.
Cannot resume.
30
●
Make the correct settings.
A Open the Control Panel.
1. On the Start screen, flick from bottom side to inside of the screen.
2. Click [All apps] on the app bar.
3. Click [Control Panel] under "Windows System".
Click (Start) - [Control Panel].
B Click [Clock, Language, and Region] - [Date and Time].
●
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support.
●
When the computer is connected to LAN, check the date and time of the server.
●
The 2100 A.D. or later year will not be correctly recognized on this computer.
●
Press F9 in the Setup Utility ( è
Setup Utility settings (excluding the passwords) to the default values. Start the Setup
Utility and make the settings again. (Note that the processing speed depends on the
application software, so this procedure may not make Windows faster.)
●
If you installed a resident software after purchase, turn off the residence.
●
The Battery Recalibration was canceled before Windows was shut down last time. To
start up Windows, turn off the computer by the power switch, and then turn on.
●
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility
( è Reference Manual "Setup Utility").
●
) or The Windows password can be used instead of the password set in the Setup Utility.
•
To set a password
A Display "Charm" and click
B Click [Create a password] under "Sign-in options".
A Click (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add or
remove user accounts].
Follow the on-screen instructions.
•
Perform the following steps, and the password will be requested when the computer
resumes from sleep (
A Open the Control Panel.
1. On the Start screen, flick from bottom side to inside of the screen.
2. Click [All apps] on the app bar.
3. Click [Control Panel] under "Windows System".
Click (Start) - [Control Panel].
B Click [System and Security] - [Require a password when the computer wakes] and
add a check mark for [Require a password].
●
One of the following operations may have been carried out. Press the power switch to turn on
the computer. Data not saved will be lost.
•
In sleep mode, the AC adaptor or battery pack was disconnected, or a peripheral was
connected or disconnected.
•
The power switch was pressed for four seconds or longer to forcibly turn off the
computer.
●
An error may occur when the computer automatically enters the sleep or hibernation mode
while the screensaver is active. In this case, turn off the screensaver or change the pattern of
the screensaver.
Reference Manual "Setup Utility") to return the
- [Change PC settings] - [Users].
) / hibernation.