Advertisement
Connection
8-pin Push-in connectors for 0,2...1,5 mm²
stranded or single wire. To avoid false connetion,
the plugs are encoded.
Power supply - 24 Volt DC:
Connecting terminal -X1 top (pins 01...04).
Two pins are available for loop trough.
Loudspeaker connectors:
Connect a 100V ELA speaker with build
in transducer at the Speaker ouputs
(-X1 Pin 5 and 7).
Audio input:
The audio input signal could connected balanced or un-
balanced (balanced input is appropriate for long cable distanc-
es up to 300m).
For unbalanced input use the
additional GND for the shield.
The micro IN (Pin 17,18)
provides phantom power, which can be used for active electret
microphones with preamp and a sensitivity of 1V (operating
voltage 9...12V) (Item No. 15.121).
Technische Daten / specifications
Power consumption
24V DC/0,79W/ - 0W Output
Power supply
10...26V DC | recommended 24V DC
requirements
Impedance
400 Ohm | 100V
Peak power output
1x 25W | 24V
Rated power output
1x 10W
THD < 0,1% 1KHz
Input impedance
22kOhm | balanced 47kOhm
Frequency bandwidth
42Hz...21KHz
High temperature, short-circuit, turn-on
Protection circuits
delay
Ambient temperature
ta -20C° ... +40°C
90x72x62mm 4 TE
Dimensions
Top-hat-rail DIN EN 60715
Protection type
IP40 > DIN EN 60529
Weight
303g
Detailierte Technische Daten finden Sie im Datenblatt.
See data sheet for further specifications.
7
Einbau / Installation
Darf nicht in der Nähe von Netzpannungsführenden Leitungen
oder Geräten eingebaut werden, es kann sonst zu Brumm-
oder Knackgeräuschen führen.
Do not install near mains voltage lines or equipment, otherwi-
se humming or clicking noises can be ocur.
8
72 mm
4 TE
9
Advertisement
